Oil Cooler Lines

Fits all automatic and manual 04-08 Mazda Rx8s.

The two lines coming off the left side oil cooler.

Short oil cooler hose from the left oil cooler to the front cover.

Also fits the 90-95 20B Cosmo.

Don't forget the oil cooler line crush washers.

M18x1.5mm

Fits hard suspension/dual oil cooler configuration.

Short oil line to the front cover on the right oil cooler.

Left most oil line (at cooler) on the right (high power) oil cooler.

Short oil cooler line on the automatic oil cooler, short line on the left manual oil cooler.

Oil line from the oil cooler to oil filter stand on the rear cast iron.

Fits both applications with single and dual oil coolers.

Keep your oil cool with the Mishimoto oil coolers and oil cooler kits!

Color: Black
Size: -10AN

Fits all 93-95 Mazda Rx7s with two oil coolers.

Yeah, we stock these.

Right oil cooler line coming off the front cover as you are sitting in the car.

Left oil cooler line coming off the front cover as you are sitting in the car.

Racing Beat's fully assembled Stainless Steel Braided Hose Sets for the 1984-1985 RX-7 GSL-SE chassis replace the original factory oil cooler hoses. Significantly less costly than the Mazda replacement units, the Racing Beat-designed RX-7 oil hose sets will easily meet the demands of street and most race applications.

Produced using Goodridge G-Line stainless steel braided hose, constructed using a seamless synthetic nitrile inner tube with an integral stainless steel braid and high tensile stainless steel outer cover. Precision-machined Goodridge aluminum alloy swivel-seal hose ends ensure a secure and superior seal. Each oil line set is carefully cut, assembled and tested by Racing Beat to ensure top-notch quality, reliability and performance.

Racing Beat's oil line sets are a direct replacement for the original factory lines - no cutting or refitting is required! Select from the adaptor fittings listed below to correctly install your oil hoses onto your chassis.

Required Adaptor Fittings:
1971-85 engines -
Part No. 11901 (3 required) Engine-to-hose adaptor (-10 to 16mm)
Part No. 11902 (1 required) Engine-to-hose adaptor (-10 to 18mm)

Racing Beat's fully assembled Stainless Steel Braided Hose Sets for the 1979-1985 RX-7 (except 84-85 GSL-SE) replace the original factory oil cooler hoses. Significantly less costly than the Mazda replacement units, the Racing Beat-designed oil hose sets will easily meet the demands of street and most race applications. (Not available for 1983-85 12A RX-7s equipped with oil-to-water oil coolers.)

Produced using Goodridge G-Line stainless steel braided hose, constructed using a seamless synthetic nitrile inner tube with an integral stainless steel braid and high tensile stainless steel outer cover. Precision-machined Goodridge aluminum alloy swivel-seal hose ends ensure a secure and superior seal. Each oil line set is carefully cut, assembled and tested by Racing Beat to ensure top-notch quality, reliability and performance.

Racing Beat's oil line sets are a direct replacement for the original factory lines - no cutting or refitting is required! Select from the adaptor fittings listed below to correctly install your oil hoses onto your chassis.

Required Adaptor Fittings:
1971-85 engines -
Part No. 11901 (3 required) Engine-to-hose adaptor (-10 to 16mm)
Part No. 11902 (1 required) Engine-to-hose adaptor (-10 to 18mm)

O-Ring for oil line connector.

84-85 13B Long Oil Cooler Line

79-82 Short Oil Cooler Line

79-82 Long Oil Cooler Line