Used to fix the threads on the flywheel end of the shaft if they get banged up.

This will fit earlier engines as well.

This bolts to the top two transmission bolts holes closest together on the intake side of the rear cast iron.

One side is fits the non-turbo teeth on the flywheel, flip it over to use the other teeth for the turbo flywheel.

This will not fit automatic Rx8 engines, unless maybe you used a huge stack of washers to line up the teeth, or got creative with the spacer; however this is not supported nor guaranteed to work.

Do not fit Rx8 Formula Mazda Flywheels.

This brush is refillable, and is great for getting into small places like corner seal, apex seal, and oil ring grooves on the rotors.

Twist the end of the handle to expose more or less bristles.

Don't forget to order brush bristle refills.

Includes one bristle set.

Refill bristles for the mini hand brush.

1-1/4" Effective Length

0.002" (0.051mm), 0.003"(0.076mm), 0.004" (0.102mm), 0.005" (0.127mm), 0.006" (0.152mm), 0.008" (0.203mm), 0.011" (0.279mm), 0.012" (0.305mm), 0.013" (0.330mm), 0.014" (0.356mm), 0.016" (0.406mm), 0.018" (0.457mm), 0.02" (0.508mm), 0.022" (0.559mm), 0.025" (0.635mm), and a 2.5" ruler.

Good for measuring rotary engine parts such as apex seal to groove clearance.

Measures metric and imperial standard.

Great for cleaning hard to reach carbon out of rotor grooves.

Nickel plated handle, stainless steel tip, 7-3/8" overall length.

Mandrel for use with Sanding Roll Cartridges (ARE954).

You will have to remove some material from the end for it to fit flush with our sanding roll cartridges.

For use with our Sanding Roll Mandrel (ARE953).

These fit snugly into the corner seal groove on the rotors.

Only use these to break free carbon and rust. DO NOT go to town on your corner seal groove with these or you will make your corner seal groove go out of spec.

Great for cleaning carbon off of rotors and other engine parts.

Wooden handle for our thick file.

Used to remove/install the 5th gear lock nut.

Meausres metric and imperial.

No Wires. No Tools. No Fuss.
Just Stick it and Flip it.

The Flipit400 is a 400 lumen C•O•B LED light that operates like a standard household light switch. You can flip to High Mode for 400 lumens of intense bright light, or flip it halfway for 100 lumens of bright light to extend the battery life. Flipit400 includes hook & loop double-sided tape and 2 magnets for two easy mounting options, as well as a drywall screw hole for permanent mounting.

Each pack comes with two Flipit400's.

2 LIGHT MODES
• HIGH (400 lumens) - 5 hours / 28 meters
• LOW (100 lumens) - 20 hours / 16 meters

DESIGN
• Water and impact-resistant plastic design
• Powerful magnets, double-sided hook and loop
   tape, and screw hole for mounting

OPERATION
• Front-positioned, ON/OFF switch 

BATTERIES
• Powered by 3 AA batteries (included)

SPECS
• 0.35 lbs.
• Size: (L) 4.5” x (W) 3.15” x (D) 1.25”

For those pesky jobs that really need a good sanding.

Doubles as a pet.