- Rotary Engine Parts
- New Engines
- Rotor Parts
- Gasket Kits
- Rotors
- Bearings
- Rotor Housings
- Side Housings & Parts
- Eccentric Shafts & Parts
- Oversize Engine Bolts
- Tension Bolts
- Front Covers & Parts
- Stationary Gears
- Counterweights
- End Play/Front Engine
- Dowel Pins
- Torque Braces
- Motor Mounts
- Engine Belts
- O-Rings & Seals
- Pulleys & Hardware
- Engine Hooks
- Inspection Dust Plates
- Engine Covers
- Rotor Timing
- Piston Engine Parts
- Rebuild Kits
- Gaskets & O-Rings
- Front Hub Bolt
- Timing Gaskets
- Transmission
- Distributor/Crank Angle
- Body
- Clutch Hydraulics
- Carburetor
- Gasket Kits
- Intake Manifold
- Exhaust Gaskets
- Front Cover Gaskets
- Oil System
- Coolant System
- Turbo Gaskets
- Throttle Body
- Emissions System
- Engine Install Gasket Kits
- Actuator Gaskets
- Fuel Level Sensor
- Fuel Pressure Regulator
- Fuel Pump Gaskets
- Mass Air Flow Sensor
- Head Gaskets
- Valve Cover Gaskets
- Intake & Fuel
- Stock Intake Manifolds
- Choke Cables
- Nuts, Bolts & Studs
- Fuel Lines & Clips
- Intake Gaskets & O-Rings
- Fuel Pressure Regulators
- Fuel Rails & Parts
- Fuel Injectors & Parts
- Fuel Filters & Parts
- Fuel Pumps & Parts
- Fuel Level Sensors
- Fuel Pulsation Dampers
- Air Filter Boxes & Parts
- Air Filter Elements
- Cold Air Intakes
- Throttle Position Sensors
- Throttle Bodies & Parts
- Air Temp Sensors
- Fuel Temp Sensors
- Air Flow Meters & Parts
- Fuel Pressure Gauges
- Stock Carburetors & Parts
- Fuel Tanks & Parts
- Aftermarket Induction
- Gas Caps
- Throttle Cables & Brackets
- Intake Ducting
- Actuators & Parts
- Fuel Leakage Sensors
- Nitrous Kits
- Coolant System
- Oil System
- Dry Sump System
- Oil Sensors & Valves
- Oil Metering System
- Oil Lines & Fittings
- Oil Coolers & Parts
- Oil Cooler Mount O-Rings
- Oil Pumps & Parts
- Gaskets & O-Rings
- Oil Pick Up Tubes
- Oil Pans, Etc.
- Regulators
- Oil Filters
- Oil Filter Relocation Kit
- Oil Caps
- E-Shaft Oiling System
- Oil Fill Tubes
- Oil Filter Stands
- Oil Gauges
- Blind Plugs
- Dipsticks & Pipes
- Oil Separator Tanks & Parts
- Electrical System
- Ignition System
- Exhaust System
- Transmission
- Transmissions
- Bearings
- Automatic Clutch Packs
- Input Shafts
- Gear Hubs & Sleeves
- Bell Housings
- Rebuild Seal Kits
- Torque Converters
- Tail Shafts & Parts
- Transmission Gears
- Pans & Gaskets
- Filters/Strainers
- Shifter Solenoid
- Vacuum Modulators
- Vent Covers
- Transmission Hoses
- Tranny Hardware
- Input Shaft Seals
- Revolution Sensors
- Transmission Mounts
- Front & Rear Seals
- Pilot Bearings
- Reverse Switches
- Release Bearings
- Starters
- Shifters & Parts
- Shift Selector Forks / Rod Ends
- Speedo Cables & Parts
- Front Covers & Gaskets
- Neutral Safety Switches
- Synchro Rings
- Clutch Forks & Parts
- Flex Plates
- Rear Differential
- Emission Control
- Anti-Afterburn Valves
- Emission Gaskets
- Air Control Check Valves
- Shutter Valves
- Air Pumps & Parts
- Air Control Valves
- By-Pass Air Control Valves
- EGR Valves
- Thermal Wax Valves
- PCV Valves
- Solenoids
- 1 Way Check Valves
- Vacuum Catch Tanks
- Cold Start Assist
- Emission Hoses & Pipes
- Altitude Compensators
- Thermostat Valves
- Oxygen Sensors & Parts
- Flywheels/Clutches
- Suspension & Steering
- Pitman Arms
- Steering Knuckles
- Suspension Bushings
- Suspension Springs
- Anti-Sway Bars
- Coilover Suspension Kits
- Shocks, Struts & Parts
- Ball Joints
- Idler Arms
- Wheels & Parts
- Camber Adjustment
- Control Arms & Hardware
- Steering Racks & Parts
- Tie Rods & Ends
- CV Joints & Boots
- Steering Column & Parts
- Subframe Mounts
- Suspension Links & Parts
- Suspension Brackets
- Suspension Braces
- Steering Gear Box
- Cam Bolts, Nuts, Washers etc
- Lowering Kit
- Brake System
- Chassis & Body
- Body Plugs
- Mud Guard Wheel Arch Liners
- Air Dams, Skirts
- Convertible Top Parts
- Engine Bay Insulation
- Windshield Cowls & Parts
- Lights, Lenses, Etc
- Motor Mounts
- Weather Strips & Seals
- Clips
- Keys & Lock Sets
- Decals, Badges, Emblems
- Sunroof/Moonroof
- Gas Door & Parts
- Under Trays
- Antennas & Parts
- Windshield Washer Parts
- Sunscreens
- Mirrors
- Cross Members
- Bumpers & Parts
- Pedals, Pads & Parts
- Rear Hatch Parts
- Doors & Parts
- Tow Hooks & Covers
- Cruise Control Cables
- Hood/Bonnet Parts
- Windows & Parts
- Firewall Grommets
- Trunk Parts
- Front End Grills/Noses
- Rear Spoilers & Parts
- Body Vents
- Drive Line & Parts
- Wind Blockers
- HVAC
- Race Parts
- Supercharger Kits
- Nitrous Kits
- Transmission
- Intake System
- Internal Engine
- Cryo Treated
- Oil System
- Coolant System
- Fuel System
- Braking System
- Exhaust System
- Clutch System
- Lightweight Flywheels
- Competition Mounts
- Ignition System
- Suspension
- Shifter Parts
- Pulleys
- Water Injection
- Porting Templates
- EFI Upgrade
- Air Filters Elements
- Ram Air Intake Kits
- Aftermarket Gauges
- Engine Management
- Turbo System
- Hoses
- Interior
- Overhead Console & Parts
- Center Console Parts
- Shifter Parts
- Floor Mats
- Dome Light Lenses
- Gauges
- Seats & Parts
- Knobs
- Dash Vents
- Instrument Clusters Lenses
- Metering Hoods
- Clips
- Knee Pads
- Tape Decks/Radios
- Cigarette Lighters
- Sun Visors
- Switches
- Cup Holders
- Ash Trays
- Interior Trim
- Glove Boxes & Parts
- Clocks
- Door Handles & Parts
- Block Off Plates
- Oil, Lube, Solvents, Etc
- Tune Up Kits
- Rotary Marine
- One Rotor Parts
- Apparel, Stickers, Etc
- Christmas Ornaments
- Rotary Puzzles & Boxes
- Beach Towels
- Work Lights/Flash Lights
- Shopping Bags
- Patches
- Key Lanyards
- Air Fresheners
- Cups
- Clothing Accessories
- Valve Stem Caps
- Fuzzy Dice
- Plush Rotary Toys
- Mazda Pennants
- Rotor Watches
- Drink Coasters
- Oil Dipstick Handles
- Jewelry
- T-Shirts
- Key Chains
- Stickers
- Rotor Clocks
- Rotor Shaped Baking
- Manuals & Videos
- Tools
- Porting & Polishing
- Services
- No Longer Available Bits
- Rx8 Take Off Parts
Tools
Mazda Rotary Engine Tools
Sort by:Recommended
Rotary Engine Flywheel Nut 54mm Box Wrench (0820-49-035) - NLA
Out of stockNo Longer Available.
Works on all 54mm rotary engine flywheel nuts.
Tired of using a chisel and a hammer to get your flywheel off? Don't have enough leverage?
Try our enormous tool!
Just put both hands on our long tool and give it a good hard push.
You will also need a flywheel ring gear brake.
Eccentric Shaft Die (ARE911)
Used to fix the threads on the flywheel end of the shaft if they get banged up.
79-11 Rx7 & Rx8 Flywheel Ring Gear Brake (ARE923)
This will fit earlier engines as well.
This bolts to the top two transmission bolts holes closest together on the intake side of the rear cast iron.
One side is fits the non-turbo teeth on the flywheel, flip it over to use the other teeth for the turbo flywheel.
This will not fit automatic Rx8 engines, unless maybe you used a huge stack of washers to line up the teeth, or got creative with the spacer; however this is not supported nor guaranteed to work.
Do not fit Rx8 Formula Mazda Flywheels.
Mazda Pilot Bearing Puller Tool End (4912-85-073) - NLA
Out of stockNo Longer Available.
Only the chuck end for the puller tool.
This only fits the Mazda OEM pilot bearing puller, a good deal if yours is destroyed.
These will not fit the Atkins Designed Pilot Bearing & Dowel Pin Puller Tool.Mini Hand Brush (ARE950)
This brush is refillable, and is great for getting into small places like corner seal, apex seal, and oil ring grooves on the rotors.
Twist the end of the handle to expose more or less bristles.
Don't forget to order brush bristle refills.
Includes one bristle set.Mini Hand Brush Bristle Refill (ARE9501)
Refill bristles for the mini hand brush.
1-1/4" Effective Length
Feeler Gauge Set (ARE951)
0.002" (0.051mm), 0.003"(0.076mm), 0.004" (0.102mm), 0.005" (0.127mm), 0.006" (0.152mm), 0.008" (0.203mm), 0.011" (0.279mm), 0.012" (0.305mm), 0.013" (0.330mm), 0.014" (0.356mm), 0.016" (0.406mm), 0.018" (0.457mm), 0.02" (0.508mm), 0.022" (0.559mm), 0.025" (0.635mm), and a 2.5" ruler.
Good for measuring rotary engine parts such as apex seal to groove clearance.
Measures metric and imperial standard.
Stainless Steel Pick (ARE952)
Great for cleaning hard to reach carbon out of rotor grooves.
Nickel plated handle, stainless steel tip, 7-3/8" overall length.
Sanding Roll Cartridge Mandrel (ARE953)
Mandrel for use with Sanding Roll Cartridges (ARE954).
You will have to remove some material from the end for it to fit flush with our sanding roll cartridges.
Sanding Roll Cartridge (ARE954)
For use with our Sanding Roll Mandrel (ARE953).
These fit snugly into the corner seal groove on the rotors.
Only use these to break free carbon and rust. DO NOT go to town on your corner seal groove with these or you will make your corner seal groove go out of spec.Rotary Engine Seal Case (49-0813-250) - NLA
Out of stockNo Longer Available.
Put the seals from your rotors in this case to keep them in order for re-assembly.
Nebo Leo Pocket Work Light & Spot Light (NE-6657) - NLA
Out of stockNo Longer Available.
These things are amazing and cheap!
You will get one flash light of random color, black, gray or orange.
The LEO™ is an amazingly versatile pocket light. Fully dimmable and equipped with Memory Power Setting, the LEO’s work light and spot light pivot and rotate to direct the light wherever you need it. A pocket clip, magnetic base and a kick stand / hanging hook give the LEO endless options of hands-free lighting.
3 LIGHT MODES
• Work Light (220 lumens) - 5 hours / 22 meters
• Spot Light (80 lumens) - 7 hours / 52 metersDESIGN
• Rotating directional light
• Non-slip rubber coating
• Water and impact-resistant
• Fully dimmable
• Memory Power Setting
• Pocket clip
• Powerful magnetic base
• Kick stand / hanging hookOPERATION
• Top-positioned, ON/OFF button; hold to dimBATTERIES
• Powered by 3 AAA batteries (included)SPECS
• 0.7 lbs.
• Length: 6.625” / Extended: 9.75”
• Width: 0.75” / Depth: 1.375”Nebo Flipit400 (NE-6699)
No Wires. No Tools. No Fuss.
Just Stick it and Flip it.The Flipit400 is a 400 lumen C•O•B LED light that operates like a standard household light switch. You can flip to High Mode for 400 lumens of intense bright light, or flip it halfway for 100 lumens of bright light to extend the battery life. Flipit400 includes hook & loop double-sided tape and 2 magnets for two easy mounting options, as well as a drywall screw hole for permanent mounting.
Each pack comes with two Flipit400's.
2 LIGHT MODES
• HIGH (400 lumens) - 5 hours / 28 meters
• LOW (100 lumens) - 20 hours / 16 metersDESIGN
• Water and impact-resistant plastic design
• Powerful magnets, double-sided hook and loop
tape, and screw hole for mountingOPERATION
• Front-positioned, ON/OFF switchBATTERIES
• Powered by 3 AA batteries (included)SPECS
• 0.35 lbs.
• Size: (L) 4.5” x (W) 3.15” x (D) 1.25”Universal Fit1 Grit Sand Paper (ARE958)
For those pesky jobs that really need a good sanding.
Doubles as a pet.
Regular Product