AEM Exhaust Gas Temperature Sensor Kit (30-2050)

Installation Suggestion:

Turbocharged engines:
1.5 upstream of the Turbine inlet with sensor axis in the vertical Plane and sensor end down.

Naturally aspirated:
1.5 downstream of the collector or end of exhaust manifold in the same configuration as for turbocharged applications.

Wiring: 
The wiring for the unit is simple and consists of only 2 wires. Polarity is not important. For the 30-1000, 30-1001, 30-1002, 30-1010, 30-1012, 30-1020, 30-1100, and 30-1101 units, connect 1 wire to 5 volts and the other to an open EGT input channel on the EMS. On all other EMS units, connect 1 wire to a good ground and the other to an open EGT input channel on the EMS.

AEM EMS Calibration:
Use the Wizard in AEMPro to insert the proper values in your calibration file.